Peep sight alignment12/28/2023 With this grip, they will then anchor the top of their index finger under the jaw at full draw. These archers hook the string with one finger above the arrow nock and two below. Olympic recurve archers – those who put sights on their recurve bows – usually have a three-point system for string alignment to ensure they’re looking through their sight the same way for each shot. The time you might sacrifice in failing light is more than offset by the huge gains in accuracy.) (Using a peep sight is much simpler, and it’s going to be way more accurate. Perhaps they make sure the string aligns against the riser side of their scope housing, or the bow riser itself. These archers might use a bow sight with optical alignment built in, or they use the string in some fashion to line up their sight pins in order to achieve a consistent aim. Some bowhunters opt not to use peep sights for various reasons – one of them being hunters fear not being able to see through the peep in low light conditions. If it doesn’t, just make sure the sight is in the middle of the peep, and you’ll know you’re aiming the same way for every shot. Ideally, the edges of the peep will perfectly match the edges of your scope housing. Look through the peep and line up the sight so it’s in the center. Most archers will draw to anchor, touch their nose to the string, and then have someone slide the peep up or down so that it matches their eye height. The height of the peep is set based on the archer’s anchor. This is a small circle or tube that is set into the middle of the bowstring, between the strands. A compound archer takes aim through a peep sight.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |